D.6 Preemptive Abort
{
AI05-0299-1}
[This subclause specifies requirements on the immediacy with which an
aborted construct is completed.]
Dynamic Semantics
On a system with a single processor, an aborted construct
is completed immediately at the first point that is outside the execution
of an abort-deferred operation.
Documentation Requirements
On a multiprocessor, the implementation shall document
any conditions that cause the completion of an aborted construct to be
delayed later than what is specified for a single processor.
This paragraph
was deleted.
Documentation Requirement: On a multiprocessor,
any conditions that cause the completion of an aborted construct to be
delayed later than what is specified for a single processor.
Metrics
The implementation
shall document the following metrics:
The execution time, in processor clock cycles,
that it takes for an
abort_statement
to cause the completion of the aborted task. This is measured in a situation
where a task T2 preempts task T1 and aborts T1. T1 does not have any
finalization code. T2 shall verify that T1 has terminated, by means of
the Terminated attribute.
On a multiprocessor, an upper bound in seconds,
on the time that the completion of an aborted task can be delayed beyond
the point that it is required for a single processor.
{
AI95-00114-01}
An upper bound on the execution time of an
asynchronous_select,
in processor clock cycles. This is measured between a point immediately
before a task T1 executes a protected operation Pr.Set that makes the
condition
of an
entry_barrier
Pr.Wait True, and the point where task T2 resumes execution immediately
after an entry call to Pr.Wait in an
asynchronous_select.
T1 preempts T2 while T2 is executing the abortable part, and then blocks
itself so that T2 can execute. The execution time of T1 is measured separately,
and subtracted.
An upper bound on the execution time of an
asynchronous_select,
in the case that no asynchronous transfer of control takes place. This
is measured between a point immediately before a task executes the
asynchronous_select
with a nonnull abortable part, and the point where the task continues
execution immediately after it. The execution time of the abortable part
is subtracted.
Documentation Requirement: The metrics
for aborts.
Implementation Advice
Even though the
abort_statement
is included in the list of potentially blocking operations (see
9.5.1),
it is recommended that this statement be implemented in a way that never
requires the task executing the
abort_statement
to block.
Implementation Advice: The
abort_statement
should not require the task executing the statement to block.
On a multi-processor, the delay associated with aborting
a task on another processor should be bounded; the implementation should
use periodic polling, if necessary, to achieve this.
Implementation Advice: On a multi-processor,
the delay associated with aborting a task on another processor should
be bounded.
NOTE 1 Abortion does not change the
active or base priority of the aborted task.
NOTE 2 Abortion cannot be more immediate
than is allowed by the rules for deferral of abortion during finalization
and in protected actions.
Ada 2005 and 2012 Editions sponsored in part by Ada-Europe
